![]() Reinforce door latch receiver (lip on upper door half) Install deflector on right side fresh air inletĪdd hard (insulation) foam wedge under pilot seat (thick end aft) for more leg clearance for taller pilotsĪdd protective tape to leading edge of struts and elevator Install thin weatherstrip under landing/taxi light Plexiglas cover Install upgraded carb heatbox shaft/bearingsĪdd aluminum reflective tape on inside of Plexiglas above taxi lights Replace fine mesh on lower cowl air inlet with 1/4" mesh Remove metal from right side C channel to clear oil cooler bracket Remove extra rudder springs at pax pedals ![]() Install silicone gaskets on all rockercovers Trim gear fairing if it touches the brake calipers Seal doorframe with Velcro ( Not the Hook Type ) Replace black prop control knob with standard blueĬover all camlocks and receptables with a thin teflon spray coat Insert bushings in the elevator mounting tubes when play shows up Leave lower 2 Cowl screws off on each sideĮnlarge top lower cowl holes to 1/2 inch and use Timmerman washers Anyone posting a reply here can edit or add to it. ![]() This is the current mod list from Husky e-mail list.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |